ZyXEL Communications omni.net LCD+M Manuel D’Utilisation

Page de 186
Technical Reference for ZyXEL omni.net series 
 
9-4
Dialing Out for Internal Fax/Modem 
 
Using the “M” command following the “ATD” will tell your omni.net LCD+M to automatically 
switch calls to the internal fax/modem once dialing is complete. 
Type: ATDM17146930762<enter> 
Manually Switching Communication Modes 
The manual switching functions will only be necessary if your communication software does not 
allow you to change your dial-up string. 
Conventional dialing commands: ATD, ATDT and ATDP, used by most existing communication 
software, can be mapped onto one of the new dialing commands according to the AT&O setting as 
follows: 
AT Command 
Dial string it will map to 
AT&O0 
ATD, ATDT and ATDP are the same as ATDM 
AT&O1 
Auto-selection of 64kbps and 3.1 kHz on outgoing calls 
AT&O2 
ATD, ATDT and ATDP are the same as ATDI 
AT&O3 
ATD, ATDT and ATDP are the same as ATDA 
Table 56. AT Command for Conventional dialing commands
The factory default is AT&O2. This means the modem will select ISDN data mode when you do 
not specify which communication mode to use in your dial command (i.e. ATD or ATDT).  
 
ATDMs  
This command directs the modem to go on-line, dial according to the string entered and attempt to 
establish a connection.  
If +FCLASS=0 is selected, the modem will behave as a data modem and will attempt to connect to 
another data modem. The modem will have up to the period of time specified by register S7 to wait 
for a connect. If this time expires before the modem can connect, the modem will go on-hook with 
the NO CARRIER response. This command will be aborted in progress upon receipt of any DTE