ZyXEL Communications omni.net LCD+M Manuel D’Utilisation

 

4-6

The manual switching functions will only be necessary if your communication software does not 

allow you to change your dial-up string. 

Conventional dialing commands [ATD], [ATDT] and [ATDP], used by much existing 
communication software, can be mapped onto one of the new dialing commands according to the 
[AT&O] setting, as follows: 

For ZyXEL omni.net LCD/Plus: 

AT&O0 

ATD, ATDT, ATDP are the same as [ATDB] 

AT&O2 

ATD, ATDT, ATDP are the same as [ATDI] 

AT&O3 

ATD, ATDT, ATDP are the same as [ATDA] 

Table 22. Manual Switch AT Command For ZyXEL omni.net LCD/Plus

For ZyXEL omni.net LCD+M: 

AT&O0 

ATD, ATDT and ATDP are the same as ATDM 

AT&O1 

Auto-selection of 64kbps and 3.1 kHz on outgoing
calls

 

AT&O2 

ATD, ATDT and ATDP are the same as ATDI 

AT&O3 

ATD, ATDT and ATDP are the same as ATDA 

Table 23. Manual Switch AT Command For ZyXEL omni.net LCD+M

(For more information on ZyXEL omni.net LCD+M, please refer to Chapter 9 Internal 
Fax/Modem Function) 

The factory default setting is [AT&O2] that instructs the omni.net to select ISDN data mode when 
you do not otherwise specify which communication mode to use (i.e. ATD or ATDT).