ZyXEL Communications omni.net LCD+M Manuel D’Utilisation
Technical Reference for ZyXEL omni.net series
8-3
V.110 Outgoing Protocol
Use the following commands to configure V.110 outgoing calls.
AT Command
Description
ATB10
User rate follows DTE speed (see note below).
ATB13
User rate = 2400bps
ATB14
User rate = 4800bps
ATB15
User rate = 9600bps
ATB16
User rate = 14400bps
ATB17
User rate = 19200bps
ATB18
User rate = 38400bps
ATB19
User rate = 57600bps (For Japanese version only)
The highest Async V.110 user rate depends on bit 4 of [S119]. If the DTE speed is higher than the user setting,
the user rate on the table below will be used.
the user rate on the table below will be used.
S119 bit 4 Setting
Highest Async V.110 User Rate
S119.4=0
19200 bps
S119.4=1
38400 bps for areas other than Japan (default).
S119.4=1
57600 bps for Japanese version only.
Table 44. V.110 Outgoing Protocol