Datalogic Scanning gryphon d432e Manuel D’Utilisation

GRYPHON™ D432/D432E 

 

 

 
Pair the reader to the stand paying attention to insert the handle into the stand clip. 
Correct insertion will be signaled by a beep; then, the reader will be ready to read 
barcodes. Read the configuration codes at page 70 to automatically enter in Normal 
or Pattern Autoscanning mode. 
 
 

 
Exposure and Calibration 

Two different control modes are available for managing the camera: automatic mode 
and fixed mode. 
 
The automatic mode provides three different options to get the best tuning of the 
image to be captured: 

- 

Automatic based on entire image: camera control mode based on the analysis of 
the whole image. This mode works well in most standard applications. It is the 
default setting. 

- 

Automatic based on central image: camera control mode based on the analysis 
of a restricted area positioned in the central zone of the image. This mode is 
suggested when reading small codes positioned in a dark and extensive 
background. 

- Automatic 

for 

highly reflective surfaces: camera control mode allowing to read 

codes on highly reflective surfaces. This mode is suggested, for example, when 
reading codes positioned on plastic or metal surfaces. 

 
The fixed mode is particularly suggested for expert users. It requires a camera 
calibration to adjust the acquisition parameters to the ambient light conditions. The 
defined values will always be used when working with a fixed exposure. 
 
These values are permanently saved in the reader memory. 
 
Refer to page 50 for configuration codes. 
 
Aiming System Calibration 
 
The factory-defined Gryphon™ D432/D432E aiming system is already correctly and 
precisely calibrated to the Gryphon™ D432/D432E focus distance and therefore 
works for the most typical applications. However, it is possible to modify the aiming 
system precision for the following condition: