Nilfisk scrubtec 586 Manuel D’Utilisation

   Operator’s Manual - SCRUBTEC R Manual Steering

  

How To Handle the Packed Machine
The machine is packed in a specifi c package provided on a pallet so that it 
can be moved with a forklift.  

1.  Remove the outer package.

2.  The machine is fi xed on the pallet with banding straps and wooden 

blocks to prevent movement during shipment.  Remove the bands and 
blocks.

3.  Remove tie down brackets.

4.  Lower the ramp.  The machine can be lowered off the pallet if the 

operator is thoroughly familiar with its operation.  Avoid violent blows 
to the base unit.

5.  Keep the pallet for future transport necessities.

The batteries are fi tted in the battery compartment under the seat and 
recovery tank (fi gure 4).  The machine uses six - 6 volt batteries.  They must 
be handled by using appropriate lifting equipment suitable for the weight and 
for the coupler system.  For maintenance and daily recharge of the batteries, 
it is necessary to follow all instructions given by the manufacturer.  

For Battery Installation follow these steps (See fi gure 4):

1.  Make sure that the key switch is in the “OFF” position.

2.  Lift and rotate the base support of the seat forward.

3.  Lean the seat on it’s restraint cable.

4.  Lift the front of the recovery tank and rotate it towards the rear until it 

rests on it’s restraint cable.

5.  Put the batteries into position and connect the battery cables as 

shown in fi gure 3.

6.  Rotate the recovery tank and then carefully rotate it forward to the 

normal operating position.

7.  Lower the base support of the seat.
 

NOTE:  Charge the batteries before using.

revised 1/11