Manualsbrain.com
  1. Manuels
  2. Marques
  3. Fujitsu
  4. softune f2 mc-16
  5. Manuel D’Utilisation

Fujitsu softune f2 mc-16 Manuel D’Utilisation

Télécharger
Page de 354
155
CHAPTER 2  DEPENDENCE FUNCTIONS
2.3.4.2
Data Break
The data break is a function to abort the program execution when the data access (read 
or write) is done to the address specified while executing the program.
■
Data Break
The data break is a function to abort the program execution when MCU accesses data as for a specified
address. It is possible to set it in this two debuggers.
When a break occurs due to a data break, the following message is displayed on the Status Bar.
Break at Address by databreak at Access address
■
Setting Method
The data break is controlled by the following method.
•
Command
- SET DATABREAK
Refer to "3.9 SET DATABREAK (type 1)" in "SOFTUNE Workbench Command Reference Manual".
•
Dialog
- Breakpoints set dialog [Data] tab
Refer to "4.6.4 Breakpoint" in "SOFTUNE Workbench Operation Manual".
Note:
When the debugging area is set again, all breakpoints in the area are cleared.