Fujitsu softune f2 mc-16 Manuel D’Utilisation

205

CHAPTER 2  DEPENDENCE FUNCTIONS

■

Set the MCU operation mode.

There are two operation modes: the debugging mode, and the native mode. Choose either one using the SET

RUNMODE command.

At emulator start-up, the MCU is in the debugging mode.

The data access to internal bus may not be detected by emulator in native mode. Therefore, when the MCU

operation mode is changed, all the following are initialized:

- Data breakpoints

- Trace measurement settings and trace buffer

■

All the operations of evaluation chips can be analyzed, but their operating speed is slower than that of mass-

produced chips.

■

Evaluation chips have the same timing as mass-produced chips to control the operating speed. Note that the

restrictions the shown in Table 2.4-1 are imposed on the debug functions.

Applicable series 

Restrictions on debug functions 

Common to all series 

- When a data read access occurs on the MCU internal bus, the internal 

bus access information is not sampled and stored in the trace buffer.

- Even when a data break or event (data access condition) is set for 

data on the MCU internal bus, it may not become a break factor or 
sequencer-triggering factor.

- The coverage function  may fail to detect an access to data on the 

MCU internal bus.