Navigon 7310 Manuel D’Utilisation

User’s manual NAVIGON 7310 

Switching on the NAVIGON 7310 

- 15 - 

places. This enables the device to calculate a route between a starting 
point and a destination. 
Calculation of the current position and its representation on the map 
take place approximately once every second. In other words, your 
current position is always shown on the map. 

1. Press 

the   (On/Off) key and keep it pressed until the device 

switches on. (Approx. 2 seconds) 
If password protection has been activated, the E

 

window opens. 

2.  Enter the password. 
3. Tap 

on 

OK. 

The N

 window opens. 

 

Note: When you switch on the NAVIGON 7310 for the first time, you 
will be asked to make the following settings: 

► 

your preferred language for using for the software 

► 

the unit of length for distances 

► 

the time format 

 

 

Note: If you have not used the NAVIGON 7310 for a long time, the 
battery may be flat. 
In this case the device must first be connected to the car charger cable 
or to a suitable charger and be charged for approximately 3 minutes 
before it can be switched on. 
Charging takes a relatively long time when the navigation device is 
activated. If you are not using the navigation device, switch it off or to 
standby for charging purposes. 
Chargers and other accessories are available in the NAVIGON online 
shop at 

1

 

If you forget your password, follow the procedure described in 
"

2

Forgotten your password?" on page 

2

Switching the navigation device to standby mode 

► 

Press briefly (max. 2 seconds) on the 

 (On/Off) key. 

- or -