National Instruments 321042A-01 Manuel D’Utilisation
© National Instruments Corp.
2-1
STD-GPIB for Windows
Chapter 2
Hardware Configuration and Installation
Hardware Configuration and Installation
This chapter contains instructions to help you configure and install your STD-GPIB.
Warning:
Electrostatic discharge can damage some components on your
STD -GPIB. To avoid such damage in handling the module, touch the
antistatic plastic package to a metal part of your computer chassis before
removing the module from the package.
STD -GPIB. To avoid such damage in handling the module, touch the
antistatic plastic package to a metal part of your computer chassis before
removing the module from the package.
The STD-GPIB default settings are suitable for most STD/STD32 systems. However, if
any of the following situations is true, you must reconfigure the hardware.
any of the following situations is true, you must reconfigure the hardware.
•
If the default settings conflict with another device in your system
•
If you need to install more than one STD-GPIB
•
If your system CPU board supports only 8-bit STD bus transfers
If you already have STD -GPIB modules installed in your system, you can run the GPIB
Information utility to determine how the modules are configured. For more information
about the GPIB Information utility, refer to Chapter 4, Debugging Your Application , in
the NI-488.2 User Manual for Windows.
Information utility to determine how the modules are configured. For more information
about the GPIB Information utility, refer to Chapter 4, Debugging Your Application , in
the NI-488.2 User Manual for Windows.
Table 2-1 shows the default settings for the switches and jumpers on the STD-GPIB.
Table 2-1. Hardware Default Settings
Characteristic
Default
Setting
Base I/O Address (hex)
2C0
DMA Channel
5
Interrupt Line (IRQ)
None*
Operation Mode
16-Bit
*
The jumper settings for any interrupt level depend on which computer you are using
(Ziatech or WinSystems), so the STD-GPIB is shipped with interrupts disabled.
However, the NI-488.2 software is configured to use IRQ11 by default and will not
function properly until you disable interrupts in the GPIB software configuration
utility. Your hardware and software settings must match.
(Ziatech or WinSystems), so the STD-GPIB is shipped with interrupts disabled.
However, the NI-488.2 software is configured to use IRQ11 by default and will not
function properly until you disable interrupts in the GPIB software configuration
utility. Your hardware and software settings must match.
To modify the default settings of the STD-GPIB, refer to the Configure the Hardware
section of this chapter. If you do not need to reconfigure the STD-GPIB, refer to the
Install the Hardware section.
section of this chapter. If you do not need to reconfigure the STD-GPIB, refer to the
Install the Hardware section.