Ford 2008 explorer Manuel D’Utilisation
Operating the HomeLink
姞 Wireless Control System
To operate, simply press and release
the appropriate HomeLink
the appropriate HomeLink
威 button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the
event that there are still
programming difficulties, contact
HomeLink
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the
event that there are still
programming difficulties, contact
HomeLink
威 at www.homelink.com or 1–800–355–3515.
Erasing HomeLink
姞 buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink
威 buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
威 is now in the train (or
learning) mode and can be programmed at any time beginning with Step
2 in the “Programming” section.
2 in the “Programming” section.
Reprogramming a single HomeLink
姞 button
To program a device to HomeLink
威 using a HomeLink威 button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
威 button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
releasing the HomeLink
威 button, follow Step 2 in the “Programming”
section.
For questions or comments, contact HomeLink
威 at www.homelink.com
or 1–800–355–3515.
2008 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
74