Daewoo sd-2100p Manuel D’Utilisation

36

■ For timer recordings, clock, date, and stations must be set correctly. 
■ Load a cassette with its safety tab in place and with sufficient free space for the recording.

Call the VideoPlus menu.
From your TV magazine, type in the number next to
the programme you want to record ... 

... and confirm. 

Decide if you want to record "ONCE", "WEEKLY" or
"DAILY"...

... and confirm.

If you wish to make changes:
Move to the position you want to change using the
[< / >] buttons. 
Change the setting using the [< / >] or [number]
buttons. If all setting are ok, press [OK], till you see
“OK: CONFIRM” in the bottom line.
Confirm.

0-9:VIDEOPLUS NUMBER
< :CORRECT
OK:CONFIRM       SETUP:END

VIDEOPLUS

83077----

HOW OFTEN DO YOU WANT

TO RECORD THIS PROGRAM?

PR+/-:SELECT
OK:CONFIRM       SETUP:END

TIMER  PROGRAM (ONCE)

PR

03

START TIME

21:20

END TIME

22:20

START DATE

14/03(THU)

TAPE SPEED

SP

PDC/VPS

ON

PR+/-:SELECT (AV1/AV2)

0-9 : SETUP (PR)

</>

:CORRECT

OK:CONFIRM              SETUP:END

ONCE

WEEKLY(ONCE A WEEK)

DAILY(MON-FRI)
DAILY(MON-SAT)
DAILY(MON-SUN)

• PDC is a service provided by some stations to enable you to perform timer recordings 

precisely even if the broadcaster delays the start time of the programme slightly. The time

you enter is the PDC time so must be correct. Not all stations offer PDC, in which case the

player will start at the time you enter and not the actual start time of the programme.
If you wish to start recording at a specific time without it being adjusted by the  PDC system

in the event of a delay, switch PDC off otherwise the player will not record.

• If you don’t have the VideoPlus numbers see next page  for the normal timer.
• If you have made a mistake, move back to the relevant position with the [<] button and

change the setting.

• If there is no programme location displayed under “PR” in the change menu, the player

doesn’t yet know the location number for the programme you want. Type it in and this will

be stored for last recordings.

• If you wish to record from a satellite receiver, select under “PR” the satellite programme

location or AV (1/2) (depending on the connection with the antenna cable or the SCART-

cable). Leave the satellite tuner switched on and to the programme you want. 

• Should programming overlap, you get a warning.
• To cancel the recording press the   button (stop) more than 5 seconds.
• VideoPlus is a trademark applied for by Gemstar Development Corp.. The VideoPlus

system is manufactured under license from Gemstar Development Corporation.

CHECK UP!

DV6T711P-AP(DESUK)1  02.7.24 11:17 AM  ˘

` 36   mac001  300DPI 120LPI