Dakota Digital lat-nr380 Manuel D’Utilisation

LED Tail Lights for 1973-74 Nova. 

 

MAN# 650233 

Installation:   

 

1.  Remove the tail light assembly from the vehicle by removing the original bulb sockets from the 

housing.  Then remove the housing hardware so it can be removed from the car.  Remove the 
housings from the vehicle carefully so the housing to body gaskets are not damaged.    

      

2.  Next remove the lens.  The lens has tabs locking it into the plastic housing.  Pry the tabs gently 

with a screwdriver to remove lens. 

    

                 

                    

3.  Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is 

recommended. 

4.  Remove the mounting plate from the bottom of the assembly which is attached with two 3/8” 6-

32 machine screws.  The LED assembly is fastened to the mounting block on a slotted hole as 
shown in the picture below.  This will normally be secured in the center of the slot but can be 
adjusted up or down to move the tail light focus. 

 

 

 

MAN# 650233