Navman 5605 Manuel D’Utilisation

TRACKER 5505/5505i/5605 Installation and Operation Manual

NAVMAN

12 User card display

A C-MAP™ user card is an optional plug-in card
that can store data files (see section 1-3). There
are three types of files: waypoints, routes or
a track.
To go to the user card display, press

select Other, then select User card.

Note:
1 Before using a user card, remove any

chart card and plug the user card in.
When you have finished with the user
card, remove the user card and replace
the chart card (see section 1-3).

2 The older 5 volt cards are not

supported.

The user card display has:
File list
A list of the files on any user card in the
TRACKER. If there are more files than will fit
on the display, press

to scroll up or

down a page at a time.
Waypts, Routes
The number of waypoints and routes currently
in the TRACKER.
Track 1 to Track 5
The number of points in tracks 1 to 5 currently
in the TRACKER.
Note:
1 To save TRACKER data onto the user card,

use the Save command (see below).

2 Data stored on the user card and shown

on the file list is not available to be used by
the TRACKER until loaded into the TRACKER
with the LOAD command (see below).

Saving data to the user card
This saves all the TRACKER’s waypoints, all
the TRACKER’s routes or one of the TRACKER’s
tracks to one file on the user card.
1 Press

and select

Save.

2 Select

Waypts, Routes

or Tracks.

3 For

Tracks,

select the track number to

save.

4 The new file is created. Change the name if

required. The new file appears in the
file list.

Loading data from the user card to the
TRACKER
This loads one file from the user card to the
TRACKER:

A waypoints file: The new waypoints are
added to any existing waypoints in the
TRACKER. If a new waypoint has the same
name as an existing waypoint but has
different data, the TRACKER displays both
waypoints. Select:

Skip:

Do not load the new waypoint.

Replace

: Load the new waypoint and

replace the existing one.

Skip all:

Do not load any new

waypoints which have the same names
as existing waypoints.

Rplc. all:

Load all new waypoints

which have the same names as existing
waypoints; the new waypoints replace
the existing waypoints.