Fujitsu fi-6770 Manuel D’Utilisation

5

Using ScandAll PRO, you can test-scan documents to check if they are scanned with the ADF correctly. 

For how to scan documents with the flatbed, refer to “Chapter 4 Various Documents” in the Operator’s 

Guide.

The following describes how to test-scan a document:

1

Press the “I” side of the main power switch of the scanner.

Press the [Power] button on the Operator Panel.

The scanner is turned ON, and the Power LED on the Operator Panel lights in green.

Note that while the scanner is being initialized, the indication of the Function Number Display 

changes as; "8" 

D

 "P" 

D

 "1", where "1" means that the Operator Panel is in the Ready Status.

   

2

3

If you see an error indication other than the above on the Function Number Display, refer to 
“Chapter 7 Troubleshooting” in the Operator’s Guide.
Ex. :If “U” is displayed on the Function Number Display, it means that the Transport Lock 
remains locked. In such case, you need to unlock the Transport Lock.
For how to unlock the Transport Lock, refer to “Section 2 Installing the Scanner” (on page 13).

For a SCSI connection, turn on the scanner and confirm that the Function Number Display 
shows “1.” Then, turn on your computer.

Check

Function

Send to

Scan / Stop

Power

Check

Function

Send to

Power

Scan / Stop

Operator Panel

Function Number Display

[Power] button

Operator Panel

[Power] button

Function Number 
Display