Frigidaire fafs4272lr Manuel D’Utilisation

19

Í

The vent latch may become dislodged from hinge point 

if door closure is attempted while latch arm is not in 

an acceptable closing position. The latch arm can be 

snapped back in at the hinge location. Washer will still 

operate without latch arm installed.

The estimated total cycle time will be displayed when 

the cycle is selected. The time may increase if water 

pressure is low, oversudsing occurs or the load becomes 

unbalanced. The approximate time remaining will be 

displayed during the cycle.
A situation where oversudsing has been detected by the 

washer will result in the washer automatically adding up 

to 4 extra rinses to attempt to clear the suds. Each extra 

rinse the washer performs to clear the suds will add 5 

minutes to the cycle display time. If an excessive amount 

of detergent has been added and additional rinsing has 

not corrected the issue, “

TOO MUCH DETERGENT

” will be 

displayed.
Vent Latch

Help prevent odor buildup and mildew between washes 

by utilizing your washer’s vent latch feature. To apply the 

vent lock, (1) open the door slightly, (2) lift the latch arm 

and then (3) press the arm down onto the plastic door 

strike, snapping it in place.
The vent latch can be released either of two ways - by 

pulling door out and manually returning latch arm to 

lower position or by pushing door shut and allowing latch 

arm to continue its pivot upward. 

DOOR LOCK

PREWASHING

WASHING

ADDING STEAM

RINSING

DRAINING

SPINNING

CYCLE COMPLETE

1

2

3

SNAP 

HINGE

Do not attempt to close door if vent latch arm is 

disengaged and arm is in an outward position. Return 

latch arm to lower position before closing and latching 

the door.