fisher--paykel ds605 Manuel D’Utilisation

599464 

 

8

Dishwasher Diagnostics can only be entered in Power Off mode, i.e. when 
there is no display on the LCD or the badge LED’s are off.  Diagnostics is 
entered by holding the KEYLOCK  and START/PAUSE buttons 
simultaneously for 5 seconds.  Ensure that KEYLOCK is pressed first. 
 

There are currently four levels of diagnostics.  To move to the next level, 
press POWER.  To enter a level, press START/PAUSE.  Once a level has 
been entered, pressing POWER will exit diagnostics completely.  If no level is 
entered, then the display will cycle through the four levels and exit after the 
last.  On entering diagnostic mode, the first level is the Display/Download 
Mode. 

In this mode, all LED’s and LCD segments (except keylock) are illuminated. 

An optical data download is available here to download all EE data to a PC or 

Palm PC via the lower tub-home sensor light pipe.  Hold the reader pen over 

the lower tub-home sensor light pipe and press START/PAUSE to initiate the 

download.  A short beep indicates the start and finish of download. 

 

The last two faults are displayed on the LCD (secondary control panel LEDs 
for integrated and flat door models) during the optical download.  The Current 

Fault code is displayed first followed by the Previous Fault Code.  To read the 

Fault Code on the secondary display, refer to Section 4.7 on Fault Codes. 

To clear the current fault code, press the KEYLOCK button until a beep is 
sounded.  This action moves the current fault into the previous fault while 
clearing the current fault.  To clear the previous fault code, press KEYLOCK 

once more until the beep is sounded. 
Warning:  Once a fault code has been cleared, it is permanently removed 

from memory and cannot be recovered. 
 
Press POWER to advance to the next level.