Furuno gp-31 Manuel D’Utilisation
7-10
7.11 Resetting Trip Distance
1. Press the [MENU] key once or twice to
open the menu.
2. Select PLOTTER and press the [ENT]
key.
3. Select the RESET TRIP? field and press
the [ENT] key. The following display
appears.
appears.
Figure 7-19 Reset trip window
4. Press the [ENT] key to reset trip dis-
tance.
5. Press the [MENU] key twice to finish.
7.12 Uploading, Downloading
Waypoint, Route Data
Waypoint, Route Data
Waypoint and route data may be down-
loaded to a PC or uploaded from a PC to
your unit.
loaded to a PC or uploaded from a PC to
your unit.
Wiring
Your equipment provides a wiring diagram
which shows how to connect to a PC using
a DSUB 9-pin connector (EIA-574). You
may display it as follows.
which shows how to connect to a PC using
a DSUB 9-pin connector (EIA-574). You
may display it as follows.
1. Press the [MENU] key once or twice to
open the menu.
2. Select I/O SETUP and press the [ENT]
key.
3. Select WIRING INFO and press the
[ENT] key to display the wiring diagram
Figure 7-20 Connection of GP-36/GP-31
to PC using a DSUB 9-pin connector
A DSUB 25-pin (EIA-232) may also be used
to make the connection. In this case the
wiring diagram is as follows.
to make the connection. In this case the
wiring diagram is as follows.
Figure 7-21 Connection of GP-36/GP-31
to PC using a DSUB 25-pin connector
Setting for communication software
on PC
on PC
Baud Rate:
4800 bps
Character Length: 8 bit
Stop Bit:
Stop Bit:
1 bit
Parity:
None
X Control:
XON/OFF
Downloading/Uploading between
PC and GP-36/GP-31
PC and GP-36/GP-31
The following data can be downloaded/up-
loaded between a personal computer and
the GP-36/GP-31:
loaded between a personal computer and
the GP-36/GP-31:
• Waypoint data (In alphanumerical order)
• Route data ( In order of route number)
Note 1: There are two kinds of data for route
data: route data and route comment data.
data: route data and route comment data.