Intel express 550t Manuel D’Utilisation
500.bok : 50003 62 Fri Sep 11 14:52:16 1998
C H A P T E R 3
Standard Configuration
62
4
Click
Enable spanning tree on this port
.
If there is a check mark in the box, the port is used in STP. If
the box is empty, the port is not used in STP.
the box is empty, the port is not used in STP.
5
Click
OK
.
Changing the cost of the
path
path
The higher the cost, the lower the chance of this port being used for
forwarding traffic, if there is an alternative route. When possible, give
a port a low cost if it is connected to a faster network segment. To
change the overall cost of the path between a port and the segment:
forwarding traffic, if there is an alternative route. When possible, give
a port a low cost if it is connected to a faster network segment. To
change the overall cost of the path between a port and the segment:
1
Click the port you want to change.
2
Select
Port Setup
.
3
Click
Spanning Tree
.
4
Select the
Port status
box.
5
In
Path cost
, type the required value.
6
Click
OK
.
Changing priority of the
port in the spanning tree
port in the spanning tree
The higher the value, the lower the chance of this port being used as
the designated or root port. To change the priority value:
the designated or root port. To change the priority value:
1
Click the port you want to change.
2
Select
Port Setup
.
3
Click
Spanning Tree
.
4
Select the
Port status
box.
5
In
Priority
, type the required value.
If there are two ports with the same value, the port with the
lowest port number is chosen.
lowest port number is chosen.
6
Click
OK
.