National Instruments SCXI-1121 Manuel D’Utilisation

© National Instruments Corporation

6.

Snap the cover back in place.

7.

Reinsert the rear grounding screw. The terminal block is now ready to 
be connected to the front panel connector.

Figure E-4.  Cover Removal

Follow these steps to install the SCXI-1302:

1.

Install an SCXI-1180 feedthrough panel as described in the SCXI-1180 
Installation section.

2.

Wire the terminal block as described in the SCXI-1302 Wiring 
Procedure section.

3.

Connect the SCXI-1302 terminal block to the front panel connector on 
the SCXI-1180 feedthrough panel. Be careful to fit the thumbscrews in 
the thumbscrew cutouts.

4.

Tighten the top and bottom captive screws on the back of the terminal 
block into the screw holes in the front panel. This will hold the 
SCXI-1302 securely in place.

5.

Check the installation.

50-Pin 
Connector

Grounding 

Screw

Thumbscrew Cutout

Step 1

Step 2

Insert Screwdriver in 
Groove and Rotate to 
Pry Open