National Instruments SCXI-1121 Manuel D’Utilisation

© National Instruments Corporation

3.

Turn off your SCXI chassis.

4.

Slide the selected module out of the SCXI chassis.

5.

Remove the module cover.

6.

Place one jack screw on the SCXI-1121 as indicated in Figure 2-8.

7.

While holding the jack screw in place, insert the lock washer and then 
the nut. Notice that you might need long-nose pliers to insert the 
washer and nut.

8.

Tighten the nut by holding it firmly and rotating the jack screw.

9.

Repeat steps 6 through 8 for the second jack screw.

10. Replace the module cover and tighten the grounding screw.

11. Slide the module back in place.

12. Connect the SCXI-1330 to your module connector and secure it by 

tightening both mounting screws.

Figure 2-8.  Assembling and Mounting the SCXI-1330 Connector-and-Shell Assembly

Mounting Screw

Lock Washers

Nut

Jack 

Screws

Grounding Screw

Mounting Screw

Nut

Shell Assembly

SCXI-1121 Module

Shell Assembly

Connector