Line 6 AXSys 212 Manuel D’Utilisation

Chapter 2: The Guided Tour

AxSys 212 User Manual

Stereo Line Out

If you want to connect the AxSysÕ output to another amp, or into a mixing
board, connect a stereo TRS (tip-ring-sleeve) cable to the

HEADPHONE /

STEREO LINE OUT

jack on the rear panel. This jack provides a stereo line

level output. If you want to use the

STEREO LINE OUT

without the internal

speakers playing as well, disconnect the speakers.

When you connect a cable to the

HEADPHONE/STEREO LINE OUT

jack , the

AxSys automatically enables its Speaker Emulator which simulates the frequency
response of the speakers and the cabinet. However, if you leave the AxSysÕ internal
speakers connected while using the

HEADPHONE/ STEREO LINE OUT

jack , the

speakers will sound noticeably darker.

If you want to turn off the automatic Speaker Emulator when you
use the

HEADPHONE/STEREO LINE OUT

jack, hold down the Row

Select button labeled

GRAPHIC EQ

and

TREMOLO/CAB

while turning on

the amp (we chose that button because it corresponds to the
Cabinet parameters, which makes it easier to remember). The
display will temporarily flash

HPn and OFF to indicate that the

Headphone Speaker Emulator has been temporarily disabled. To
enable it again, turn the amp on again without holding any buttons.

Powering Up

Once all connections are made, turn down the

MASTER

volume and power

up the AxSys 212 with the

POWER

switch located on the AxSys rear panel

over the power cord.

The display should look something like this:

P01

This means that Preset Sound Bank 01 is selected.

After power-up, the AxSys will recall the Sound that was selected before it
was last turned off. The display will indicate the current:

¥ Mode:

Preset, User or Edited

¥ Sound Bank:

01 through 32

...and one of the four

SOUND

LEDs (▼) will be lit to indicate the current:

¥ Sound:

A, B, C or D