VTech dect 6.0 ds6211-4 Manuel D’Utilisation

3

Each newly purchased handset (

DS6201) must be registered to the 

telephone base (

DS6211, DS6221 or DS6222) before use. When first 

purchased, each expansion handset shows 

NOT REGISTERED. You may 

need to charge the handset before registering to the telephone base. For 

more details on battery charging, see the table on page 2.
To make registration easier, read all of the instructions on this page before 

you begin. 
To register a handset:

Place the unregistered handset in the telephone base. If 

HS 4 SEC ON BASE does not appear on the handset screen after a few 

seconds, remove the handset and place it in the telephone base again.
On the telephone base, press and hold  

FIND HANDSET for about four seconds 

(until the red 

IN USE light on the telephone 

base turns on) and then release the button. 

The handset shows 

PLEASE WAIT... and 

it takes up to 60 seconds to complete the 

registration. The handset shows 

X REGISTERED (X represents the handset 

number assigned) and you hear a beep 

when the registration completes.

When the registration is complete, the newly registered handset is assigned 

the next available handset registration number. For instance, if you already 

have 

HANDSET 1 and HANDSET 2, the next registered handset will be 

HANDSET 3.

1.

2.

When the registration fails, the handset shows 

NOT REGISTERED. To  

  reset the handset, remove the handset from the telephone base and place it  

  back in. Try the registration process again.

You cannot register a handset if any other system handset is in use.
Only one handset can be registered at a time.

•

•
•