Hobart ML-104562 6460C Manuel D’Utilisation

– 2 –

Models 6430 and 6430T Peelers are designed to peel 30 to 33 lbs (13.5 to 15.0 kg) of product in 1 to
3 minutes using a 

3

/

4

 HP, single- or three-phase electric motor. The 6430T includes a synchronous timer

and is available for single-phase electrical service ONLY.

Models 6460 and 6460T Peelers are designed to peel 50 to 60 lbs (22.5 to 27.0 kg) of product in 1 to
3 minutes using a 1 HP, single- or three-phase electric motor. The 6460T includes a synchronous timer
and is available for single-phase electrical service ONLY.

All models incorporate a reinforced peeling disc with the abrasive permanently bonded  to its surface
and a Lexan Liner for the inside of the hopper. The switch or timer is mounted on the right side of the
discharge chute as standard but can be ordered on the left or changed in the field. The bottom of the
peeler unit is cushioned with a rubber trim molding which also provides a seal.

Optional accessories include a peel trap or disposer stand.

NOTE: Immediately after unpacking, machine should be checked for possible shipping damage. If the
machine is found to be damaged after unpacking, save the packaging material and contact the shipper.

This machine MUST be cleaned after installation and before being put into service. Refer to
MAINTENANCE for instructions.

1. Remove the peeler from its shipping carton and remove the hopper top.

2. Remove the fill tube and bracket assembly from the peeler housing and the cloth bag containing

the fill tube gasket and acorn nuts.

3. Do NOT remove the rubber molding on bottom of peeler.

4. Lay the peeler on its side. Slightly loosen the clamp that attaches the drain hose and pull the drain

hose down so that it extends approximately 

7

/

8

" below the bottom of peeler housing. Tighten the

clamp.

On units that will NOT use a peel trap or disposer stand, attach the bottom cover plate using the bolts
and washers supplied with the unit.