calibre calibredl ins Manuel D’Utilisation

1. Consult with vehicle owner about LED location. For best visibility, choose a

mounting location as close to the vehicle gauges as possible. 

2. Check for proper clearance behind the area where the LED(s) will be

installed (approximately 1”) and drill a 3/16” hole in the chosen location
for the LED(s). CALIBRE DL models require the mounting of a second 
LED for rear radar warnings. 

3. Route all of the LED wires under the dash per DIAGRAM A1.

&   R e c o m m e n d e d

P r o c e d u r e s

1. Consult with vehicle owner about Pod location. For best visibility, choose a

mounting location as close to the vehicle gauges as possible. 

2. Before mounting the Warning Pod(s), clean both the Pod surface and

desired mounting location on the dash with rubbing alcohol.

3. Position the Warning Pod(s) on the dash with the provided double stick

“O” ring tape. CALIBRE DL-P models require the mounting of a second
Pod for rear radar warnings.

4. Route the black cable(s) from the Warning Pod(s) through or under the

dash per DIAGRAM B1.

1. Remove the under dash

panel and mount the Interior
Network Module using the
supplied cable ties to the
existing factory wire looms,
brackets, or other support
structures as per DIAGRAM
C1. The Interior Network
Module can be mounted hor-
izontally or vertically under
the dash.

2. Connect the LED, ignition-on,

and ground wires per the
separate enclosed block 
diagram sheet.