beiter vt Manuel D’Utilisation

Sight Pin Tool

Install Insert

Extract Insert

HINTS:
Installing Inserts: It is very important to hear the 
"click", to be sure you have installed the insert 
correctly.
Removing Inserts: Push the Sight-Pin Tool in the 
direction of the arrow. Because of the slightly conical 
Sight-Pin Tool, the tunnel will open and the Insert can 
be removed without any problem.
Important! Clip in the inserts #7 and #17 horizontal 
so the vibrations of the Fluor Pins can be absorbed 
better. 

Inserts for the Beiter Sight 
Tunnel can be easily installed 
and extracted with the Sight Pin 
Tool.
Code Number: VTTOOL

Code-numbers:
- VTWWGRKL-> Level for Sight Tunnel Ø12, Green/Clear Body
- VTWWGRSW-> Level for Sight Tunnel Ø12, Green/Black Body

A Level is available for the Beiter Sight Tunnel Ø12. This 
Level can easily be installed and removed, without any tool. 
Even if the Level can not be used during FITA tournaments 
(but for example in IFAA tournaments!), it can be a very 
important tool during training sessions to learn to hold the 
bow straight or to learn to shoot better in Field 
Tournaments.

Fixation on the sight: 
When in conjunction with the Sight Tunnel, the O-Rings are working 
as a friction, allowing the thread to be turned without loosing any 
nuts! (pic.1)
O-Rings (OR4X2 for 8-32 or M4, OR5X2 for 10-32) absorb vibrations 
on Sight Tunnel and Scopes, thereby preventing them working 
loose.  

HINTS: 
Remove the Fluor Pin from 
the insert, every time you 
pack away your bow. It is 
best to remove the Pin every 
time,  so the plastic will not 
be affected. Otherwise it is 
possible that it could drop 
from the Sight Tunnel while 
shooting.
To preserve the Pin, it is a 
good idea to simply put it 
into your Beiter Armguard! 

Important! Clip in the 
inserts #7 and #17 
horizontal so the vibrations 
of the Fluor Pins can be 
absorbed better. 

pic.1