eutech-instruments cyberscan con 11 conductivitytds meter Manuel D’Utilisation

Instruction Manual 

 

CON 11/110 

 

13

Your electrode features a built-in temperature sensor. The temperature sensor is 
factory calibrated. Calibrate your sensor only if you suspect temperature errors may 
have occurred over a long period of time or if you have a 
replacement electrode. 

1.  Make sure the electrode is attached to the 6-pin 

connector. The ATC annunciator will appear at the 
bottom right-hand corner of the LCD.  

2.  Switch the meter on. Press the CAL/MEAS key to 

enter conductivity or TDS calibration mode. The CAL 
indicator appears above the primary display.  

3.  While in conductivity or TDS calibration mode, press 

the MODE key to enter temperature calibration 
mode. The primary display shows the current 
measured temperature reading based on the last set 
offset and the secondary display shows the current 
measured temperature reading based on factory 
default calibration.  

4.  Dip the electrode into a solution of known 

temperature (i.e. a temperature bath). Allow time for 
the built-in temperature sensor to stabilise.  

5. 

Scroll with the MI/▲ or MR/▼ keys to set the correct 
temperature value (i.e. the temperature of the 
temperature bath). You can adjust the reading in 
increments of 0.1 °C.  

6.  Once you have selected the correct temperature, 

press the HOLD/ENTER key to confirm. The meter 
will be calibrated and return to the measurement 
mode.  

NOTES:  

•  To exit this program without confirming the 

temperature calibration value, DO NOT press 
HOLD/ENTER. Press CAL/MEAS instead.  

•  If the ATC indicator does not light up, see SETUP 

menu Program P1.3 to switch it on. See page 40. 

•  Since temperature readings affect the accuracy of 

conductivity / TDS measurements, it is strongly 
recommended to carry out a conductivity / TDS 
calibration after a temperature calibration is done. 

1413

1413

22.3

1413

22.0

22.3

22.3

22.0

22.3

µS

µS

1425

µS