eutech-instruments alpha ph differential probe Manuel D’Utilisation
Instruction
manuals
ECFP21A1A1
2
1.2. Intended use
ECFP21A1A1 1½ inch pH sensor is designed to continuously measure pH and temperature in aqueous
solutions in accordance with the technical product specifications in Section 2.2 of this manual.
Any other use, or use not mentioned here, that is incompatible with the technical specifications is deemed
inappropriate. The operator is solely responsible for any damage arising from such use.
Other prerequisites for appropriate use include:
solutions in accordance with the technical product specifications in Section 2.2 of this manual.
Any other use, or use not mentioned here, that is incompatible with the technical specifications is deemed
inappropriate. The operator is solely responsible for any damage arising from such use.
Other prerequisites for appropriate use include:
• Observing the instructions, notes and requirements set out in this instruction manual.
• Observing all local safety regulations.
• Observing all warnings and cautions in the documentation regarding all products used in this
• Observing all local safety regulations.
• Observing all warnings and cautions in the documentation regarding all products used in this
measurement system, including the pH sensor, mounting hardware, analyzer electronics and
cabling.
cabling.
• Observing the prescribed environmental and operational conditions.
• Observing chemical compatibility with all wetted materials.
• Observing chemical compatibility with all wetted materials.
1.3. Safety Instructions
The ECFP21A1A1 1½ inch pH sensor should be installed and operated only by
personnel familiar with the sensor and qualified for such work.
A defective sensor should be returned to Eutech Instruments for repair or
replacement. Contact Eutech Instruments to obtain a Return Goods Authorization
(RGA) number.
No modifications to the ECFP21A1A1 1½ inch pH sensor are allowed. The
(RGA) number.
No modifications to the ECFP21A1A1 1½ inch pH sensor are allowed. The
manufacturer/supplier accepts no responsibility for damage caused by unauthorized
modifications. The risk is borne entirely by the user.
modifications. The risk is borne entirely by the user.
1.4. Removal from Service / Correct Disposal of the Sensor
Removal from Service
• Disconnect the cable wiring from the controller terminal block.
• Remove the sensor from the mounting hardware.
Correct Disposal of Unit
• When the sensor is taken out of service, observe the local environmental regulations for correct
disposal.