eutech-instruments silversulfide epoxy Manuel D’Utilisation

Instruction Manual 

 

Silver/Silver Sulfide Electrode 

 

23

- Clean and rinse the electrodes thoroughly. 
- Prepare the electrodes properly. 
- Use the proper filling solution. 
- Adjust the pH and the ionic strength of the solution by the use of the proper ISA. 
- Measure correctly and accurately. 
- Review 

TROUBLESHOOTING HINTS.

Whenever problems arise with the measuring procedure that has been used successfully in the past, 
be sure to check the standard and reagent solutions. If in doubt about the credibility of any of the 
solutions, prepare them again. Errors may result from contamination of the ISA, incorrect dilution 
of standards, poor quality distilled or deionized water, or a simple mathematical miscalculation. 
 

Look for possible interference, complexing agents, or substances which could affect the response or 
physically damage the sensing electrode (or the reference electrode) if the electrodes work perfectly 
in the standard, but not in the sample. Try to determine the composition of the samples prior to 
testing to eliminate a problem before it starts. (See 

Measuring Hints, Sample Requirements

, and

 

.) 

 

Be sure that the electrode's limit of detection has not been exceeded and the analysis method is 
clearly understood and is compatible with the sample. 
 
Refer to the instruction manual again. Reread the sections 

  and 

 
If trouble still persists, call Eutech Instruments Pte Ltd. at (65) 6778-6876 and ask for the Customer 
Services Department.