lift-master star450-315 Manuel D’Utilisation

This device complies with FCC Rules Part 15 and IC Canada Rules

and Regulations. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference

and (2) this device must accept any interference received,

including interference that may cause undesired operation.
Removable memory modules and RF module are included in this

product. Jumper J2 must remain in the default position unless

otherwise noted. THERE ARE NO OTHER SERVICEABLE PARTS.

Mounting Instructions for STAR450  . . . . . . . . . . . . . . . . . . . . . .1
Programming For STAR450  . . . . . . . . . . . . . . . . . . . . . . . . . . .2-3
Troubleshooting Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Electrical Connections for STAR450  . . . . . . . . . . . . . . . . . . . . . .4
STAR450 Features  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

 

  

 

 

 

 

 

 

 

 

 

Select a convenient location near your device to be

controlled by the STAR450. For best performance, the STAR450

should be mounted in “Line-Of-Sight” with your intended

transmitting location. Avoid mounting the STAR450 in or on
metallic enclosures.

If this is unavoidable, we recommend

installing the antenna extension kit (86LM) for best results. See

Remote Antenna Mounting for proper installation.
Receiver Mounting:

Mount back plate to desired surface using #6

hardware (not provided). Hardware used will depend on mounting

application (refer to Figure 1 for receiver mounting hole

locations). Wire electrical connections to unit. Snap unit to back

plate.
Direct Antenna Mounting:

Install the provided antenna onto the

STAR450 antenna connector by screwing the connector

clockwise. Slide the seal boot down to meet the O-ring, covering

the antenna hardware.

Antenna

Antenna
Connector

Seal Boot

Use the optional 86LM antenna

extension kit to mount the remote antenna as high and far from

metal as possible for best radio range (Figure 2). Contact

LiftMaster customer service at: 1-800-528-2806 to order the

model 86LM.

To prevent possible SERIOUS INJURY or DEATH from

electrocution:
• Be sure power is not connected BEFORE installing the

receiver.

To prevent possible SERIOUS INJURY or DEATH from a

moving gate or garage door:
• ALWAYS keep remote controls out of reach of children.

NEVER permit children to operate, or play with remote

controls.

• Activate gate or door ONLY when it can be seen clearly, is

properly adjusted, and there are no obstructions to door

travel.

• ALWAYS keep gate or garage door in sight until completely

closed. NEVER permit anyone to cross path of moving gate

or door.

T A B L E   O F   C O N T E N T S

M O U N T I N G   I N S T R U C T I O N S   F O R   S T A R 4 5 0