lift-master sw470 Manuel D’Utilisation
Installation
15
Doc 01-G0665
Rev C
0 1 -G 0 6 6 5 F4
3/4”-10 x 3 HEX HEAD BOLT
(82-HN75-28)
(82-HN75-28)
3/4” FLAT WASHER (80-575)
3/4” BUSHING
(12-10172)
(12-10172)
EXTENSION ARM
HOLDER (08-2001)
GATE BRACKET
(W-2001) OR
EXTENSION ARM
(10-2026-T)
3/4” FLAT WASHER (80-575)
3/4” FLAT WASHER (80-575)
3/4” SPLIT LOCK WASHER
(85-LS-38)
(85-LS-38)
3/4”-10 HEX NUT (84-RH-75)
Figure 9
4 Model SW 470: Set the control arm stops on the operator in the positions appropriate for the
installation. Then install the control arm and hub assembly to the operator output shaft.
Attach control arm extension to arm hub with ¼ -20 black plastic knobs provided as shown in
Figure 10. Place hub onto shaft with key and secure using set screw. Be sure rubber seal is
on end of hub to keep water out of bearing.
Attach control arm extension to arm hub with ¼ -20 black plastic knobs provided as shown in
Figure 10. Place hub onto shaft with key and secure using set screw. Be sure rubber seal is
on end of hub to keep water out of bearing.
Assemble extension arm to control arm as shown in Figure 11. Be sure to keep the extension
arm with spot-faced side up. Use the holes that are appropriate for desired degree of gate
opening. The extension arm should swivel easily on pivot screws when the nuts are tightened.
Attach the other end of the actuator arm to the gate brackets shown.
arm with spot-faced side up. Use the holes that are appropriate for desired degree of gate
opening. The extension arm should swivel easily on pivot screws when the nuts are tightened.
Attach the other end of the actuator arm to the gate brackets shown.
0 1 -G 0 6 6 5 F5
BLACK PLASTIC
KNOB (80-2103)
KNOB (80-2103)
ARM HUB
(07-2101)
(07-2101)
KEY (80-2112)
BEARING
(12-3000)
SHAFT
(11-2101)
HOUSING
(10-2101-T)
ARM CHANNEL
(10-2108-T)
Figure 10