lift-master tcg2 Manuel D’Utilisation
CONFIGURATION & DIP SWITCH SETTINGS
3
24V AC/DC
CH1 N/O
CH2 N/O
DELTA-3/LINEAR
MULTI-CODE
STANLEY
MULTI-CODE
STANLEY
DIP
SWITCHES
CONFIGURATION
SWITCH
CHANNEL 2 DIP SWITCH
CHANNEL 1 DIP SWITCH
TM
TM
TM
FIGURE 4
FIGURE 2
MULTI/ STANLEY
(1 THRU 10)
LINEAR/ DELTA-3
(1 THRU 8)
1 2 3 4 5 6 7 8 9 10
O
N
N
O
F
F
F
F
T M
T M
DIP
SWITCH
Step 3 Setting the Configuration Switch
The TriCode
The TriCode
TM
receiver is factory set for Linear/Delta-
3
TM
.
Locate the configuration switch and set it to the
desired RF mode of operation (Refer to figures 2 and 4).
Modes are as follows:
desired RF mode of operation (Refer to figures 2 and 4).
Modes are as follows:
Linear/Delta-3
TM
: works with all “Linear/Delta-3
TM
”
transmitters transmitted at 310 MHz using 8-bits ID
system.
system.
Multi
TM
: works with all “Multi-Code
TM
” transmitters
transmitted at 300 MHz using 10-bits ID system.
Stanley
TM
: works with all “Stanley
TM
radio” transmitters
transmitted at 310 MHz using 10-bits ID system.
Step 4 Setting DIP Switch
The TriCode
The TriCode
TM
receiver DIP switch CH1 is factory set
OFF (1-10) and CH2 is factory sett ON (1-10).
Locate the 10 position DIP Switch. If this is a new
installation using TriCode
installation using TriCode
TM
transmitters, randomly set
switches matching those of the transmitters. Never
use factory setting. If receiver is used with
Linear/Delta-3
use factory setting. If receiver is used with
Linear/Delta-3
TM
, Multi-code
TM
or Stanley
tm
transmitters, match the receiver DIP Switch to the
above transmitters. Some transmitters may use
toggle switches and it may be difficult to determine
‘ON’ & ‘OFF’. If so, try reversing the setting on the
TriCode
above transmitters. Some transmitters may use
toggle switches and it may be difficult to determine
‘ON’ & ‘OFF’. If so, try reversing the setting on the
TriCode
TM
DIP Switch (Refer to figures 3 and 4).
Note: In 'LINEAR/DELTA-3
TM
' mode (8-bits system)
the last 2 bits (DIP #9 & 10) settings are ignored.
They can be left in either ‘ON’ or ‘OFF’ settings.
They can be left in either ‘ON’ or ‘OFF’ settings.
D E LTA - 3 / L I N E A R
M U LT I - C O D E
S TA N L E Y
3 1 0 M H z
3 0 0 M H z
3 1 0 M H z
T M
T M
T M
CONFIGURATION
SWITCH
FIGURE 3