dhi rpm4 rack mount kit pn 401929 installation instructions Manuel D’Utilisation

 

RPM4  is a trademark, registered and otherwise, of DH Instruments, Inc.

 

Document 560061b 

041124 

4765 East Beautiful Lane 

Phoenix  AZ  85044-5318 

USA 

 

Tel 602.431.9100

Fax 602.431.9559

dhi@dhinstruments.com

www.dhinstruments.com

 

 

RPM4™ 

Rack Mount Kit 

Installation Instructions 

 

1 123699 

1  Front 

panel 

2 124155 

2  Side 

bracket 

4 

100972-Z 

3 

M4 hex nut 

4 

102668-Z 

4 

M4 split lock washer 

4 

101016-Z 

5 

M4 x 12 SHC screw 

4 

100918-Z 

6 

M4 flat washer 

1 

123703 

7 

Rear support bracket 

1 123764 

8  Foam 

gasket 

4 

103448-Z 

N/A  

M3 x 12 self-tapping screw 

 

 

Remove the four feet from the bottom of the 
RPM4™ by removing the screw and then 
removing the foot. Replace the screw with the 
shorter M3 x 12 self-tapping screw included in this 
kit.  Repeat for the other three feet. 

  Place one side bracket (2) on each side of the RPM4.  

Position each bracket with the front panel 
attachment flange (flange with two holes) facing 
the front of the RPM4. 

  Attach the front panel (1) to the side brackets (2) 

using four M4 split lock washers (4) and four M4 
hex nuts (3).  Recommended torque is 3 Nm. 

  Remove adhesive backing from foam strip (8). 

Adhere the foam strip to the rear support bracket 
(7), centering the foam as shown in figure 2. 

 

Attach the rear support bracket (7) to the side 
brackets (2) using four M4 flat washers (6) and 
four M4 X 12 SHC screws (5).  Recommended 
torque is 3 Nm. 

 

For adequate support of the RPM4, the rear 
support bracket (7) shall be supported on the side 
rails of the rack system or by other means. 

 

 

Figure 1.  Rack Mount Kit 

 

 

Figure 2.  Rear Support Bracket and Foam