Becker 7941 Guide De Montage
Installation Guide
16
Installation/ Removal of the Cascade
•
Installation:
The Cascade features an integrated universal bracket for
DIN installation slots. An installation frame is not required.
The Cascade is inserted into the installation slot and secured with
the slides supplied.
To install, complete all electrical connections. Remove the
control panel. Then push the Cascade into the installation slot.
Subsequently, insert slides into the openings on the front of the
Cascade as far as the first detent position (Fig. A). Now lock the
radio in by pulling on both slides as shown in Fig. B. Subsequently,
remove the slides.
The Cascade features an integrated universal bracket for
DIN installation slots. An installation frame is not required.
The Cascade is inserted into the installation slot and secured with
the slides supplied.
To install, complete all electrical connections. Remove the
control panel. Then push the Cascade into the installation slot.
Subsequently, insert slides into the openings on the front of the
Cascade as far as the first detent position (Fig. A). Now lock the
radio in by pulling on both slides as shown in Fig. B. Subsequently,
remove the slides.
•
Removal:
To remove the Cascade, it must first be unlocked. To do this,
remove the control panel and push in both slides as far as the
second detent position as shown in Figure A . Then take hold of
the Cascade on both sides and pull it out (Fig. C). Next, remove
the slides by pressing the springs on the right and left sides of the
Cascade. If the Cascade was previously installed in another vehi-
cle, it may be necessary to adjust the springs on the unit before
installationCascade. To adjust the springs, insert slide as shown in
Fig. D and subsequently adjust as shown in Fig. E (Gently press
slide in the direction of 1 while at the same time moving the slide
in the direction of 2).
To remove the Cascade, it must first be unlocked. To do this,
remove the control panel and push in both slides as far as the
second detent position as shown in Figure A . Then take hold of
the Cascade on both sides and pull it out (Fig. C). Next, remove
the slides by pressing the springs on the right and left sides of the
Cascade. If the Cascade was previously installed in another vehi-
cle, it may be necessary to adjust the springs on the unit before
installationCascade. To adjust the springs, insert slide as shown in
Fig. D and subsequently adjust as shown in Fig. E (Gently press
slide in the direction of 1 while at the same time moving the slide
in the direction of 2).
The installation angle of the Cascade must not exceed 0° - 35°
(vertical). Only the enclosed bolts may be used for an attach-
ment from the rear.
(vertical). Only the enclosed bolts may be used for an attach-
ment from the rear.
A
B
C
D
E
1
2