Becker 7910 dtm hs Guide De Montage
Subject to correction and technical modifications
36
Copyright by Becker GmbH, D-76303 Karlsbad
Installation guide
Mechanical speedometer with integrated speed sensor in the speedometer cable
•
Remove the signal from the speed sensor, extend and connect to
socket A pin 1.
socket A pin 1.
•
Minimum requirement for the signal:
0 Hz - 4 kHz / square-wave signal (no inductive sensor)
Low - level < 1.5 V, high - level 5 V - 16 V
0 Hz - 4 kHz / square-wave signal (no inductive sensor)
Low - level < 1.5 V, high - level 5 V - 16 V
Mechanical speedometer without speed sensor in the speedometer cable
A speed sensor which generates a digital, speed-dependent signal must
be installed in the speedometer cable.
be installed in the speedometer cable.
The VDO adapter 2152.30300000 or a vehicle-specific adapter which
satisfies the minimum requirements can be used. The VDO speed sen-
sor is suitable for direct installation on the gearbox (no further installa-
tion parts required) or in the speedometer cable (in conjunction with
additional universal installation parts).
satisfies the minimum requirements can be used. The VDO speed sen-
sor is suitable for direct installation on the gearbox (no further installa-
tion parts required) or in the speedometer cable (in conjunction with
additional universal installation parts).
If you do not know the exact installation position / location of
the speed signal, please consult the vehicle manufacturer.
the speed signal, please consult the vehicle manufacturer.
If the sealed speedometer cable is released, a correct display
cannot be guaranteed. Incorrect installation leads to improper
functioning of the navigation system or of the speedometer.
cannot be guaranteed. Incorrect installation leads to improper
functioning of the navigation system or of the speedometer.
GAL signal
A