Panasonic ERGP81 Mode D’Emploi

11

Clean the clipper and the blade after each use. 

(If not cleaned, the motion will become poor and the sharpness 

will worsen.)

• Make sure that the clipper is turned off.

1. Brush off any hairs from the 

clipper and from around the 

blade.

2. Brush off the hairs from the 

blade edge.

3. Brush the hairs out from 

between the stationary blade 

and the moving blade while 

pressing down on the cleaning 

lever to raise the moving blade.

• Apply lubrication oil to the blade before and after each use.

Apply a drop of the lubrication oil to 

each indicated point. 

Attach the blade to the main body, turn 

on the power and allow to run for 

approximately 5 seconds. 

Failure to apply the lubrication oil may 

cause the following problems due to 

rust, wear or burn out.

‑ The clipper has become blunt.

‑ Shorter operating time.

‑ Louder sound.

►

Replacement part is available at your dealer or Service Centre.

Replacement parts for ER‑GP81 Blade

WER9900

Lubrication oil WES003P

• Do not use any blade other than the one dedicated as it may 

cause defect in performance.

• We recommend Panasonic lubrication oil WES003P.

Use the cleaning brush to clean hair trimmings and dust in the 

charging plug or in the hole on the bottom surface.

ER-GP81_UK.indb   11

2017/04/03   9:30:55