Panasonic ESWH90 Mode D’Emploi

When using the appliance for the first time

Check that the output level suits your skin.
Treated skin may temporarily turn red or feel painful depending
on the body type or condition of the person using the appliance.

Set the output level to 1 (LV1) and flash the treatment area

once.

After 2 days

If there are no skin abnormalities

Set the output level to 1 (LV1) and start treatment on the

area that you want.

• Guide for treatment frequency, time (See page 14.)

After 2 weeks*

If there are no skin abnormalities
*For armpits/bikini line/face: after 1 week

To increase the output level for treatment, flash once on

the treatment area, and check your skin condition for

around 2 days before further treatment. Increase the

output level one step at a time.

• If there is intense pain or

redness after 2 or more
days, stop using the
appliance and consult a
dermatologist.

Greater treatment effects

LV5

LV1

LV4
LV3
LV2

Minimal pain or irritation

How to use

• The power will not turn on even when pressing the switch with

the AC adaptor connected to the main body.

• The appliance may not operate in an ambient temperature

approximately 5 °C or lower.

Remove the cap.

Attach the attachment to suit the area where you

want to use it.

Press and hold (for approximately 3 seconds)

to turn the power on.

• The power will turn off automatically if the appliance is not

used for approximately 1 minute.

Press

SELECT

to select the output level.

• Level 1 is selected when the power is turned on.

• The level cycles through 1 2 3 4 5 1…each

time the level selector switch is pressed.

• The level indication lamp blinks, and then turns on. (A beep

sounds, indicating that preparation for flash is complete.)

ES-WH90_EU.indb 16

2016/02/01 9:49:02