Panasonic KXTG1404E Mode D’Emploi
Useful Information
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
19
Transferring calls, conference calls
Outside calls can be transferred between 2 handsets. 2 handsets can have
a conference call with an outside party.
Example: When handset 1 transfers a call to handset 2
a conference call with an outside party.
Example: When handset 1 transfers a call to handset 2
1
Handset 1:
During an outside call, press {INT}. i Press {2} (desired handset
number).
L
number).
L
The outside call is put on hold.
L
If there is no answer, press {INT} to return to the outside call.
2
Handset 2:
Press {C} to answer the page.
L
Press {C} to answer the page.
L
Handset 2 can talk with handset 1.
3
Handset 1:
To complete the call transfer, press {ih}.
To establish a conference call, press {3}.
To complete the call transfer, press {ih}.
To establish a conference call, press {3}.
Transferring a call without speaking to the other handset user
1
During an outside call, press {INT}. i Enter the desired handset
number.
L k
number.
L k
flashes to indicate the outside call is on hold.
2
{ih}
L
The outside call rings at the other handset.
Note:
L
L
If the other handset user does not answer the call within 30 seconds, the
call rings at your handset again.
call rings at your handset again.
Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section,
disconnect the base unit’s AC adaptor and turn off the handset, then
reconnect the base unit’s AC adaptor and turn on the handset.
disconnect the base unit’s AC adaptor and turn off the handset, then
reconnect the base unit’s AC adaptor and turn on the handset.
Available for:
KX-TG1402/KX-TG1403/KX-TG1404
KX-TG1402/KX-TG1403/KX-TG1404
Problem
Cause/solution
w
is flashing.
L
The handset is too far from the base
unit. Move closer.
unit. Move closer.
L
L
You are using the handset or base unit
in an area with high electrical
interference. Re-position the base unit
and use the handset away from
sources of interference.
in an area with high electrical
interference. Re-position the base unit
and use the handset away from
sources of interference.
L
I cannot make or receive
calls.
calls.
L
The base unit’s AC adaptor or
telephone line cord is not connected.
Check the connections.
telephone line cord is not connected.
Check the connections.
L
The call bar feature is turned on. Turn it
off (page 15).
off (page 15).
L
You dialled a call restricted number
(page 16).
(page 16).
L
The key lock feature is turned on. Turn
it off (page 11).
it off (page 11).
The unit does not ring.
L
The ringer volume is turned off. Adjust
the ringer volume (page 14).
the ringer volume (page 14).
TG1401_1402_1403_1404E(e).book Page 19 Thursday, April 22, 2010 3:17 PM