Cisco PA-2FE-TX Guide De Spécification

If you need to shut down additional interfaces, enter the interface fastethernet command 
followed by the interface address (example: 1/1/1) of the interface. Use the no shutdown 
command to enable the interface. 

Write the new configuration to NVRAM as follows:

Router# copy running-config startup-config

[OK]

Router#

The system displays an OK message when the configuration has been stored in NVRAM.

Verify that new interfaces are now in the correct state (shut down) using the 
show interfaces command (followed by the interface type and interface address of the interface) to 
display the specific interface. 

 provides examples.

Cisco 7304 PCI port adapter 
carrier card in Cisco 7304 
routers

interface, followed by the type 
(fastethernet) and slot/port 
(module-slot-number/
interface-port-number)

The example is for interface 0 and interface 1 of a 
PA-2FE in a Cisco 7304 PCI port adapter carrier card in 
module slot 3 of a Cisco 7304 router.

Router(config)# interface fastethernet 3/0

Router(config-if)# shutdown

Router(config-if)# interface fastethernet 3/1

Router(config-if)# shutdown

Router#

Cisco 7401ASR routers

interface, followed by the type 
(fastethernet) and slot/port 
(port-adapter-slot-number/
interface-port-number)

The example is for interface 0 and interface 1 on a 
PA-2FE in port adapter slot 1.

Router(config)# interface fastethernet 1/0

Router(config-if)# shutdown

Router(config-if)# interface fastethernet 1/1

Router(config-if)# shutdown

Router#

VIP in Cisco 7500 series 
routers

interface, followed by the type 
(fastethernet) and slot/port 
adapter/port 
(interface-processor-slot-number/
port-adapter-slot-number/
interface-port-number)

The example is for interface 1 and interface 0 on a 
PA-2FE in port adapter slot 1 of a VIP installed 
in interface processor slot 1.

Router(config)# interface fastethernet 1/1/1

Router(config-if)# shutdown

Router(config-if)# interface fastethernet 1/1/0

Router(config-if)# shutdown

Router#