Select Increments JKU-POD Manuel Du Propriétaire
JKU-PODS INSTALLATION
INSTRUCTIONS
Select Increments
www.selectincrements.com
www.jeepsound.com
www.jeepsound.com
(T) 610-345-9044
Email: admin@selectincrements.com
Email: admin@selectincrements.com
** (4) screws go into the metal sport cage to affix the pods. Follow instructions for a good installation **
Tools required: Drill
3/8” Hex-Head Driver Bit
Phillips Bit
Exacta Knife or Razor Blade
Small piece ½” thick wood
Zip Ties / Cable Ties
Phillips Bit
Exacta Knife or Razor Blade
Small piece ½” thick wood
Zip Ties / Cable Ties
(Other tools possibly required): -Rotary Tool w/ Sanding Drum
-Wire cutters / crimp tool
-Other wiring accessories such as solder,
-Other wiring accessories such as solder,
glue gun, heat shrink tubing, electrical tape, etc.
*A second set of hands is helpful when attaching pods, but not absolutely necessary.
No need to unzip or remove any of this, but here’s some photos of
the driver side area where the driver side pod will go. (If the images aren’t very
clear, you can always print color copies from our site.) This picture is taken
from standing at the rear of the Jeep, fabric unzipped, exposing the ‘pop-in’
from standing at the rear of the Jeep, fabric unzipped, exposing the ‘pop-in’
foam piece and the metal sport cage. The foam pieces should not be removed.
We’re just showing you how and where the pods will affix…you don’t need to
unzip any of this to affix the pods. The pods install right on top of all of this stuff.
The foam is very rigid and doesn’t compress under screw pressure.
These two photos
show you where the
screws will penetrate
the foam and affix the
driver side pod.
(Think mirror image for
the passenger side.)
The foam can sort of
jiggle around, but that
goes away when the
pods are installed.
In these photos with
the foam piece
removed, you can
see where the
screws will enter
the sport cage on
the driver side.
(Mirror image for
passenger side.)
These instructions and all pictures show installation of the Driver Side JKU-Pod with the Kicker®
component speakers. Installing the Passenger Side JKU-Pod is the same procedure in mirror image.
Instructions should be used as a general guide to installing other component systems or coaxial speakers.
Note also in these photos how the angle of the metal is different for each screw used to affix the pod; the screw in photo (A) will enter
at a higher trajectory, more straight up toward the sky. The screw in photo (B) will enter at a lower trajectory. Why are we
showing you all of this? We want you to see this area with everything removed to help understand where the screws are going
because all of this is intact when you install the pods and we figured you may want to see exactly what/where you’re drilling into.
p.1
A
B