Simple Control Simple Cable Complete Manuel Du Propriétaire
Copyright © 2015 by Roomie Remote, Inc.
1
Simple Cable - Complete
Setup Guide
This document describes the Simple Cable - Complete, which lets you control multiple devices
using the blaster and one device each using the two emitters.
The Simple Cable - Complete is included with both Simple Blaster Complete products (Wi-Fi and
Ethernet); it is also available for
using the blaster and one device each using the two emitters.
The Simple Cable - Complete is included with both Simple Blaster Complete products (Wi-Fi and
Ethernet); it is also available for
.
H
ARDWARE
S
ETUP
The Simple Cable - Complete has a 3.5mm connector on one end that must attach directly to a
Simple Blaster. The Simple Cable - Complete cannot be used with the Simple Cable - Triport
Adapter.
On the other end, the Simple Cable - Complete has three single-cable accessories:
Simple Blaster. The Simple Cable - Complete cannot be used with the Simple Cable - Triport
Adapter.
On the other end, the Simple Cable - Complete has three single-cable accessories:
•
Emitter 1: A single emitter cable with one gray band. Configure the device being controlled
by this emitter on IR Port 1. To affix the emitter eye: remove the backing, place the emitter
eye directly over the infrared receiver of the target device, and press firmly (test device
control before removing backing).
by this emitter on IR Port 1. To affix the emitter eye: remove the backing, place the emitter
eye directly over the infrared receiver of the target device, and press firmly (test device
control before removing backing).
•
Emitter 2: A single emitter cable with two gray bands. Configure the device being
controlled by this emitter on IR Port 2. To affix the emitter eye: remove the backing, place
the emitter eye directly over the infrared receiver of the target device, and press firmly (test
device control before removing backing).
controlled by this emitter on IR Port 2. To affix the emitter eye: remove the backing, place
the emitter eye directly over the infrared receiver of the target device, and press firmly (test
device control before removing backing).
•
Blaster: A single blaster cable; no gray band. Place the blaster eye within ~25 feet and in line
of sight of the infrared receiver of all devices you want to control.
If you are controlling devices with the blaster, during software configuration you must
configure all of these devices on IR Port 3.
of sight of the infrared receiver of all devices you want to control.
If you are controlling devices with the blaster, during software configuration you must
configure all of these devices on IR Port 3.