Biketronics BT1005X Fairing and Wiring Kit Manuel Du Propriétaire

t Be sure both radio harness and module are not plugged in.

t Strip 1/4” of insulation off wires from radio harness and gently twist ends.

t Insert wires into the appropriate slot on Biketronics module according to 

chart below and module label.

t White buttons only need to be pressed to release wires.

t Note on Wired Control Output: 

 

Kenwood and JVC radios use the blue/yellow wire. All other radios use the 

3.5mm cable. It is NOT used on Kenwood or JVC radios.

(not used for 

Kenwood or JVC)