AudioQuest Niagara 1000 Manuel Du Propriétaire

7

For proper operation, the Niagara 1000 requires a safety ground (supplied via the 
power utility AC wall outlet). 

The Niagara 1000 is manufactured with four rubber feet for safe, secure placement 
on any table, cabinet, shelf, or floor. The Niagara 1000’s design obviates the need for 
compliant or high-Q isolation feet. Although many audio/video products benefit 
greatly from these devices, the Niagara 1000 does not. 

Placement or proximity to other components is not critical, and, under standard use, 
the Niagara 1000 does not produce any heat. 

Once the Niagara 1000 is placed, an appropriate 15-amp-rated AC cord must be 
connected to the AC inlet (IEC-C14) connector. The AC cord must have an IEC-C13 
female end connector and a grounded male 120VAC Edison/NEMA plug for use in North 
America or Taiwan. We highly endorse the use of any AudioQuest NRG Series 15-amp-
rated AC cord, but the Niagara 1000 will function properly with any appropriate AC 
cord that meets the aforementioned requirements. 

Whenever possible, it is best to keep at least three inches (approximately 7cm) between 
AC cables and any signal cable. When this is not possible in a practical layout of system 
cabling, crossing the AC cables to signal cables at 90 degrees is best to minimize 
induced noise.