Tascam DR-60DmkII Manuel Du Propriétaire

TASCAM DR-60DMKII

4 – Recording

CAUTION

Depending on this setting, the input level setting range changes.

For this reason, the input level might change greatly when this

setting is changed. Before changing it, you should turn the power

OFF or turn the output level all the way down.

Using phantom power

When stopped, if you change the 1/L or 2/R input switch on the

front of the unit to MIC+PHANTOM, a pop-up message appears

confirming that you want to turn phantom power on.

When the confirmation pop-up message opens, press the DATA dial

to turn phantom power on for the 1/L connector or 2/R connector

and supply phantom power (+24V or +48V) to the connected mic.
To close the confirmation pop-up message without turning

phantom power on, change the input switch to LINE or MIC.
Use the

SYSTEM

screen to set the voltage to +24V or +48V. (See

“Setting the phantom power voltage” on page 76. )

NOTE

Battery power will be consumed faster when set to +48V than

when set to +24V.

CAUTION

•

Confirm that phantom power is OFF before connecting a line

level device to a 1/L connector or 2/R connector. If you connect

a line level device while phantom power is being supplied, that

device and this unit could be damaged.

•

When using a condenser microphone, before connecting to and

disconnecting from a 1/L connector or 2/R connector, confirm

that the phantom power for that jack is OFF. If you connect or

disconnect a mic while phantom power is being supplied, that

mic and this unit could be damaged.

•

Turn phantom power ON only when using a condenser micro-

phone that requires phantom power.

•

Supplying phantom power to some types of ribbon microphones

could break them. Do not supply phantom power to a ribbon

microphone if you are in doubt.

•

When using USB bus power, the unit might not be able to supply

phantom power depending on the computer. In this case, use a

TASCAM PS-P515U AC adaptor (sold separately).

•

Some condenser microphones will not operate when phantom

power is set to +24V.

•

Do not connect or disconnect the AC adaptor when using

phantom power. Doing so could damage this device.