Marantz PM-10 Manuel Du Propriétaire

“ATT” appears on the display and the sound is muted.

0

To cancel mute, press MUTE again.

n Setting the attenuation level when

The attenuation level can be set at –20 dB, –40 dB, or –∞.

0

The factory default setting is –∞.

The attenuation level will appear on the display.

The attenuation level setting value changes each time

the button is pressed.

0

If not operated for 2 seconds, the current setting is saved

and the display returns to normal.

The volume level of the left and right channels can be

trimmed in 0.5 dB steps across a 0.0 － 9.0 dB range.
The factory default setting is 0.0 dB (maximum).

The unit enters the level adjustment mode.

0

The left channel level value flashes.

ui to adjust the left channel level.

p.

The adjustment mode selects the right channel.

0

The right channel level value flashes.

ui to adjust the right channel level.

The unit exits the adjustment mode.

0

If you have connected a “SLAVE” device using the

slave setting.

The display circuit operation can be stopped to minimize

noise from the display and the display circuit which could

interfere with the analog audio output signal.

Each time you press DISPLAY, the display and the

illumination lamp (blue) switch on/off at the same time.

0

If you operate the VOLUME knob or another control when

the display is off, the display turns on again. When

operation is finished, the display turns off automatically

after approximately 2 seconds.

The following procedure makes the illumination lamp always

off regardless of the display on/off operation.

Press and hold DISPLAY for two seconds and longer

while the lamp is always off to return to the normal

setting.

ENGLISH

18