Marantz PM-10 Manuel Du Propriétaire
PUREST
Noise sources that influence sound quality can be
suppressed in order to achieve higher quality playback by
stopping all of the following circuits.
0
Recording output circuit
0
Non-signal state detection circuit
0
Headphones circuit
ON:
Enables the high sound quality
mode (PUREST mode).
OFF
(Default):
Disables the high sound quality
mode (PUREST mode).
0
When PUREST mode is on
0
Audio output from the recorder output connectors stops.
0
The auto standby function stops working.
0
When headphones are connected, the headphones
circuit is activated and the sound output from the
headphones.
PHONO
Sets the phono equalizer of this unit according to the type or
impedance of the turntable cartridge to be connected.
MM
(Default):
Set this for an MM cartridge.
MC Low:
Use this setting for an MC cartridge of
less than 10 Ω/ohms.
MC High:
Use this setting for an MC cartridge of
10 Ω/ohms or higher.
NOTE
0
If this setting change operation is performed, playback
sound is output approximately 10 seconds after the
change. (The standby indicator blinks in red until the unit is
able to be used.)
AUTO STBY (Auto Standby)
Sets whether to automatically switch the unit to the standby
mode when there is no input signal and operation for 30
minutes.
ON
(Default):
Enable Auto Standby mode.
OFF:
Disable Auto Standby mode.
0
The display will show the remaining time for three minutes
before the units enters standby mode.
0
In F.C.B.S. connection, only the ID 1 master unit activates
Auto Standby mode. If the ID 1 master unit is operated with
no audio input, set the Auto Standby mode to off.
ENGLISH
21