Casio exilim ex-z4 Mode D'Emploi
105
PLAYBACK
To re-record audio
1.
In the PLAY mode, use [
] and [
] to scroll
through snapshots until the one whose audio
you want to re-record is displayed.
you want to re-record is displayed.
2.
Select the “PLAY” tab, select “Dubbing”, and
then press [
then press [
].
3.
Use [
] and [
] to select “Delete”, and then
press [SET].
• If you merely want to delete the audio with re-
recording, press [MENU] here to complete the
procedure.
procedure.
4.
Press the shutter release button to start audio
recording.
recording.
5.
Recording stops after about 30 seconds or
when you press the shutter release button.
when you press the shutter release button.
• This deletes the previous recording and replaces it
with a new one.
IMPORTANT!
• Keep the microphone
on the front of the
camera pointed at the
subject.
camera pointed at the
subject.
• Take care that you do
not block the
microphone with your
fingers.
microphone with your
fingers.
• Good recording results are not possible when the
camera is too far from the subject.
• Operating camera buttons during recording can
cause button noise to be included in the audio.
• The
(Audio) icon appears on the monitor screen
after audio recording is complete.
• You will not be able to record audio when remaining
memory capacity is low.
• The following types of audio recording are not
supported.
— Adding audio to a movie image
— Adding audio to a protected snapshot (page 110)
— Adding audio to a movie image
— Adding audio to a protected snapshot (page 110)
• Audio that is re-recorded or deleted cannot be
recovered. Make sure you no longer need audio
before re-recording or deleting it.
before re-recording or deleting it.
Microphone