Exegin Technologies Limited Q53 Manuel D’Utilisation

27

Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2009

v. Configuring the Q53 on Your Network
Optional TCP/IP Settings

1. Telnet to the Zigbee gateway bridge device as described on 

telnet Q53ipaddress 

2. Enter "

" for the User ID and press ENTER at the Password prompt, as by 

default there is no password set.

The following WARNING message is normal at this point and may be ignored.

You should now see the prompt:

Q53IPaddress:root>

3. Type "

" to view the Zigbee gateway bridge device’s current settings, then 

configure the Q53’s default router/gateway as follows:

4. Logout of the Telnet session with "

". Then restart the Q53 by powering the 

unit off and then on again.

The Q53 allows entry of most IP addresses either in ’dotted quad’ form or as a symbolic 
host names. Host names have the advantage that they are easier to remember and are not 
tied to a specific IP address.

The translation from host name to IP address is performed by a Domain Name Server 
(DNS). In order to use host names, the IP address for the DNS server as well as the 
domain name suffix must be specified at configuration time.

1. Follow the instructions for accessing the TCP/IP Settings form (

2. Enter the IP address of the Domain Name Server in the DNS Server Address field. 

3. Enter the suffix of the domain name in the DNS Domain Suffix field.

4. Click on "Submit" when done.

5. Go to the Restart page and click on "Restart" to apply the new settings to your 

system.