Exegin Technologies Limited Q53R6 Manuel D’Utilisation
66
Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2013
9. Reference Information
Complete Command Reference
Complete Command Reference
Set commands
These commands alter the current or working settings in memory only. They will be lost
if the Q53 is turned off then on. To ensure this does not happen, be sure to issue a "
if the Q53 is turned off then on. To ensure this does not happen, be sure to issue a "
save
"
command so the current settings get written to Flash.
Table 5—Set Command Options
Command Syntax
Description
set sysinfo hostname hostname
Set a hostname for use with DDNS.
For example:
set sysinfo hostname
Q53Plan2
set sysinfo contact
contactname
Set a person or department to contact in case
of Zigbee gateway bridge device trouble.
of Zigbee gateway bridge device trouble.
For example:
set sysinfo contact
HelpDeskx255
set sysinfo location newname
Set a descriptive name defined by newname
for the Q53 for identification purposes. This
is not used in the operation of the Zigbee
gateway bridge device in any way.
for the Q53 for identification purposes. This
is not used in the operation of the Zigbee
gateway bridge device in any way.
For example:
set sysinfo name
southwall_level2
set sysinfo from default
Set all sysinfo settings back to factory
defaults.
defaults.
set user passwd username
password
Assign a password to a defined user on the
Q53. This password must be less than
eleven characters. The username must be
either root or guest. If the new password is
not entered, the user’s old password will be
cleared.
Q53. This password must be less than
eleven characters. The username must be
either root or guest. If the new password is
not entered, the user’s old password will be
cleared.
For example:
set user passwd root mplex1
If you forget the root password, you can set
the dipswitchs to restore settings to factory
defaults. See
the dipswitchs to restore settings to factory
defaults. See
set user from default
Set all user settings back to factory defaults.
set user from stored
Set all current user settings to the stored
values in Flash.
values in Flash.