Exegin Technologies Limited Q53R6 Manuel D’Utilisation
71
Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2013
9. Reference Information
Performing Firmware Upgrades
Performing Firmware Upgrades
1. Forgotten Password
If you have forgotten a password set on the Q53, you can reset the user settings using
these commands:
these commands:
set user from default
save
2. Restore All Settings in Flash to Defaults
Since this default state is temporary and you may want to make sure all settings
sitting in Flash are back to their factory default values, you will need to use these
commands:
sitting in Flash are back to their factory default values, you will need to use these
commands:
save default
store tcpip from default
or set dipswitch 1=on and 2=off. See
3. Set dipswitches for normal operation.
Set dipswitch 1=off and 2=off. See
Performing Firmware Upgrades
Since the Q53’s firmware is stored in Flash ROM, upgrading is easy. Using a computer
with a web browser on a TCP/IP network, the Zigbee gateway bridge device can be
upgraded to a newer firmware version without needing new hardware. Please refer to
with a web browser on a TCP/IP network, the Zigbee gateway bridge device can be
upgraded to a newer firmware version without needing new hardware. Please refer to
on page 57 for step-by-step instructions on how to load new
firmware into the Q53.
Firmware File
The latest firmware file is always available at Exegin’s web site,
"
"
http://www.exegin.com/
" or it can be ordered through Exegin Technical Support.
Please see
on page 84 for further information.