Atmel Norway AS A092107 Manuel D’Utilisation

 

 

ATZB-S1-256-3-0-U ZigBit 2.4GHz Single chip Wireless Module [DATASHEET] 

42199A



WIRELESS



10/2013 

17 

This equipment complies with Part 15 of the FCC rules and regulations. To fulfill FCC Certification requirements, an 

OEM manufacturer must comply with the following regulations: 

1. 

The ATZB-S1-256-3-0-U modular transmitter must be labeled with its own FCC ID number, and, if the FCC ID 

is not visible when the module is installed inside another device, then the outside of the device into which the 
module is installed must also display a label referring to the enclosed module. This exterior label can use 
wording such as the following: 
 

IMPORTANT: Contains FCC ID : VW4A092074. This equipment complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this 

device must accept any interference received, including interference that may cause undesired operation (FCC 

15.19). 

The antenna used for this mobile transmitter must provide a separation distance of at least 20 cm from all persons and 

must not be colocated or operating in conjunction with any other antenna or transmitter. 

Installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF 

exposure compliance. This device is approved as a mobile device with respect to RF exposure compliance, and may 

only be marketed to OEM installers. Use in portable exposure conditions (FCC 2.1093) requires separate equipment 

authorization. 

IMPORTANT: Modifications not expressly approved by this company could void the user's authority to operate this 

equipment (FCC section 15.21). 

 

IMPORTANT: This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference when the equipment is operated in a commercial environment. This equipment generates, uses, and 

can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may 

cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to 

cause harmful interference in which case the user will be required to correct the interference at his own expense 

(FCC section 15.105). 

The ATZB-S1-256-3-0-U Module has been certified for use in European Union countries. If these modules are 

incorporated into a product, the manufacturer must ensure compliance of the final product to the European harmonized 

EMC and lowvoltage/safety standards. A Declaration of Conformity must be issued for each of these standards and 

kept on file as described in Annex II of the R&TTE Directive.